Introduction
Scope
The scope of this teardown encompasses the Logitech V220 and its owners/users.
Tools
-
-
Orient the mouse so you are viewing its base.
-
Using your fingers, gently remove the USB wireless receiver by sliding it towards you.
-
With your fingertip, engage the power switch to its OFF position to ensure the mouse is not powered.
-
-
-
Locate the four mouse pads.
-
Use the rectangular end of the metal spudger to get underneath each mouse pad, pry them up, and peel them off.
-
-
-
Locate the four #0 Phillips screws where the mouse pads previously were.
-
Unscrew the four #0 Phillips screws with the Phillips #0 screwdriver.
-
-
-
Once the housing screws are fully removed, slowly (and carefully) separate the top and bottom halves of the housing.
-
-
-
Gently set the mouse halves down on a flat surface.
-
Secure the base half with one hand.
-
With thumb and forefinger, grab the end of the molex and pull it away from you until the molex is unplugged.
-
-
-
Locate the one, scroll wheel, #0 Phillips screw near the very front edge of the mouse.
-
Turn the mouse 90 degrees clockwise.
-
While supporting the rear of the mouse base, unscrew the #0 Phillips scroll wheel screw.
-
Once the scroll wheel screw is fully removed, manually extract the scroll wheel and spring assembly.
-
-
-
Locate the scroll wheel spring.
-
Use the tweezers to gently remove the spring by slowly tugging the spring away from the scroll wheel assembly.
-
-
-
Locate and remove the circuit board screw.
-
Grip the edges of the circuit board.
-
Manually remove the circuit board from the base of the mold housing.
-
-
-
Flip over the top half of the mouse housing so you are viewing underneath it.
-
Locate the mouse button hooks.
-
Rotate the housing 180 degrees clockwise.
-
Using the spudger, firmly push down on each mouse button until the mouse button is released from the hook.
-
Viewing the front of the mouse, the left and right mouse buttons should be detached from the housing.
-
-
-
Hold the housing so you are looking down the battery slot.
-
Place the flat end of the spudger between the mouse buttons and the housing.
-
Pry off the mouse buttons.
-
One comment
Tyler - Very good work on this and your other work on this mouse. I appreciate your attention to detail. I wonder if you are the T. Price who used to go to MacDonalds in U/A in 1995? Thanks again so much for your professional work!