Introduction
Step by step guide for replacing your damaged LCD Display.
-
-
Remove Rear casing.
-
With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.
-
Flip over rear buttons board to expose LCD ZIF clamp.
-
Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)
-
Remove the LCD.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
