Introduction
Use this guide to replace an Edge-Sweeping Brush in your Roomba vacuum robot.
-
-
Make sure your Roomba is turned off and flip it over to access its underside.
-
Use a Phillips screwdriver to loosen the single captive screw securing the edge-sweeping brush. Make sure to keep the brush from rotating while screwing.
-
-
-
Use your fingers to gather all three brush arms and grab them simultaneously.
-
Steadily pull upwards to release the brush from its hexagonal axle. You can gently rock it back and forth if it sits too tight.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
