iPod Touch 7th Generation Lightning Connector Assembly Replacement

Written By: Tarun Thiruma
  • Comments: 0
iPod Touch 7th Generation Lightning Connector Assembly Replacement

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

prerequisite

  1. 3w4oq1BNuYsVfxQs

    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.

  2. xdSMOiURQA6cR6gR

    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

    • One 1.85 mm #000 Phillips screw

  3. DZxyZN2OZunRbQgr

    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. 5oGU1cRr2koYODBG
    5oGU1cRr2koYODBG
    yIEmPNJsRe6MMc26

    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tarun Thiruma

Member since: 20/11/19

35226 Reputation

0 comments