Introduction

  1. IMedn1XtukXIVB2M
    • Remove the two 1.6 mm Phillips #000 screws securing the rear-facing camera bracket.

    This is as far as I got. The top screw won’t come out. The bottom screw came out fine. Oh well, time to put everything back together again.

    Fredrik -

  2. n1u1ZdYZRoMddnSe
    • Remove the rear-facing camera bracket from the rear case.

    It was not noted in this guide but be sure to place the tab on the LEFT UNDER when replacing the rear-facing camera bracket

    DAXimus -

  3. qXtfYmawxfCDACOH
    • Remove the rubber camera bumper from the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Member since: 19/10/12

465332 Reputation

0 comments