iPhone 13 mini Opening Procedure

Power off your iPhone before beginning disassembly.

Remove the two 6.8 mm-long pentalobe P2 screws at the bottom edge of the iPhone.

Lay overlapping strips of clear packing tape over the iPhone's screenuntil the whole face is covered.

If you can't get the suction cup to stick in the next few steps, fold a strong piece of tape (such as duct tape) into a handle and lift the screen with that instead.

Pull the blue handle backwards to unlock the Anti-Clamp's arms.

Slide the arms over either the left or right edge of your iPhone.

Position the suction cups near the bottom edge of the iPhone—one on the front, and one on the back.

Squeeze the cups together to apply suction to the desired area.

Pull the blue handle forwards to lock the arms.

Turn the handle clockwise 360 degrees or until the cups start to stretch.

Make sure the suction cups remain aligned with each other. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms.

Support your iPhone on something sturdy such as a hardcover book so it rests hands-free and parallel to the ground; this makes it easier to work with in the following steps.

Use a hair dryer to heat along the bottom edge of the iPhone. The screen should feel slightly too hot to touch.

Wait one minute to give the adhesive a chance to release and present an opening gap.

Insert an opening pick under the screen's plastic bezel when the Anti-Clamp creates a large enough gap.

Skip the next three steps.

Use a hair dryer or a heat gun to heat the bottom edge of the iPhone for 90 seconds or until the screen is slightly too hot to touch.

If you're using a single suction handle, apply it to the bottom edge of the phone, as close to the edge as possible.

Pull up on the suction cup with firm, constant pressure to create a slight gap between the screen and the frame.

Insert an opening pick into the gap under the screen's plastic bezel.

Use a hair dryer to heat the right edge of the iPhone (the edge with the power button) for 90 seconds or until the screen is slightly too hot to touch.

Slide the opening pick around the bottom right corner and along the right edge of the iPhone, slicing through the adhesive holding the display in place.

Leave the pick in the top right corner before continuing.

Use a hair dryer to heat the top edge of the iPhone for 90 seconds or until the screen is slightly too hot to touch.

Slide the opening pick around the top right corner of the iPhone to separate the top adhesive.

Leave the pick in the top left corner before continuing.

Use a hair dryer to heat the left edge of the iPhone for 90 seconds or until the screen is slightly too hot to touch.

Insert a second opening pick in the bottom left corner of the iPhone.

Twist both picks simultaneously until the left edge clips release.

Pull on the small nub on the suction cup to remove it from the front panel.

Rotate your iPhone so the right edge faces you.

Open the iPhone by swinging the display up from the right side, like the front cover of a book.

Lean the display against something to keep it propped up while you're working on the phone.