iPad 3 Wi-Fi Front Panel Assembly Replacement

Written By: Walter Galan
  • Comments: 2
iPad 3 Wi-Fi Front Panel Assembly Replacement

Difficulty

Moderate

Steps

2

Time Required

15 - 30 minutes

Introduction

Preq for removing the front panel. Specific to the iPad 3, also involves moving the LCD over.

  1. atoL3VpjIoabuFdS

    • Remove the four 2 mm Phillips #00 screws securing the LCD to the aluminum frame.

    What is the diameter/pitch of these screws in case someone (myself) loses them?

    john Scrivener -

    At this step, since I was replacing the glass and the digitizer anyway, I simply cut the digitizer cable and set aside the largest piece of glass. Since the shattered section was over most of the digitizer cable, this made working with the remaining glass shards much easier.

    medhatmactech -

  2. Qw5PPZfIDTE6QkFD
    Qw5PPZfIDTE6QkFD
    sEismBWVYVj5itAc
    VvaeWVotEfpDhCKy

    • Using a plastic opening tool or a spudger, lift the right edge of the LCD out of the iPad.

    • Rotate the LCD along its left edge and lay it down on top of the front panel.

    • Be careful as you move the LCD. The ribbon cable is fragile and may break if it is flexed too much.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Walter Galan

694047 Reputation

0 comments