Introduction

Internal Prerequisite

  1. QGeKlkePwJ25aUqB
    • Remove the seven screws securing the logic board to the rear aluminum panel.

    • Six 2.1mm Phillips #00

    • One 2.5mm Phillips #00

  2. sTQealg4Srk5GxlF
    • Flip the logic board over, minding any cables that may get caught.

    • Using the tip of a spudger, remove the three antenna connectors from their sockets on the logic board.

    I know the middle connector goes to the left antenna. Where do the other two go?

    Anticept -

    Looking this pic, the left cable goes to the right antena and the right one to the middle antena (or whatever is there) under the front camera

    Maratech -

    Right antenna, left antenna, GPS

    Malcolm Stevens -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brett Hartt

Member since: 13/04/10

127755 Reputation

0 comments