iPad 2 GSM LCD Replacement

Written By: Walter Galan
  • Comments: 0
iPad 2 GSM LCD Replacement

Difficulty

Moderate

Steps

5

Time Required

No estimate

Introduction

Removing LCD assembly with front panel attached. Internal Prerequisite.

  1. GgpEAPntxA6vxRNQ

    • Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.

  2. kVbLPWJMMnR5TKlV
    kVbLPWJMMnR5TKlV
    2NgUVkX4OuvLLNPP

    • Lift the LCD from its long edge closest to the volume buttons and rotate it out of the rear case.

    • Lay the LCD on the front panel as seen in the second picture.

  3. JTuiuaP4DmKJagGU

    • Use the edge of a plastic opening tool to flip up the metal retaining clip securing the display data cable to its socket on the logic board.

  4. UrAkU1DOUoBuExot

    • Pull the display data cable out of its socket on the logic board.

    • Do not lift upward on the display data cable connector as you disconnect it.

  5. H2HPqeH6mTU4hp6i

    • Remove the LCD assembly from the iPad 2.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Walter Galan

694047 Reputation

0 comments