iON SnapCam 1045 Wearable HD Video Camera Battery

Written By: Olakunle
  • Comments: 0
iON SnapCam 1045 Wearable HD Video Camera Battery

Difficulty

Easy

Steps

4

Time Required

15 minutes

Introduction

This guide covers the disassembly of the iON SnapCam 1045 battery.

  1. IPgIjJTfc1pKBhQY

    • Detach the magnetic clip from the bottom of the camera.

    • The magnetic clip gets in the way of disassembly because it constantly spins and therefore a distraction so it is imperative to detach.

  2. AtfdQuKEMFoVhrCr

    • Use a spudger to gently detach the memory card and USB slot cover.

  3. CMCsnMpthspujvkF

    • Use a Phillips #000 Screwdriver to loosen the 0.008 mm screw located between the USB and memory card slots.

    • This screw is really tiny and can easily fall off and get lost! Make use of a magnetic mat to hold it in place or better still put the magnetic clip to use for keeping the screw safe.

  4. bttMuETmOTu2jFdG
    bttMuETmOTu2jFdG
    5IoC5uXJIYN3lHhK

    • Once again use the spudger to gently open the encasement.

    • The case is a little fragile and forceful entry could lead to damage of the plastic case. Thread carefully.

    • The Battery can be safely detached and replaced.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Olakunle

Member since: 11/11/17

102 Reputation

0 comments