Introduction
Prereq only
Tools
Parts
-
-
Disconnect the SATA power and data cables from the hard drive by pulling them straight away from the hard drive.
-
-
-
Remove the two T10 Torx screws securing the hard drive to the iMac frame.
-
Slightly rotate the top edge of the hard drive away from the outer case.
-
Lift the hard drive off its two lower positioning pins and remove it from the outer case.
-
-
-
Remove the two T8 Torx screws securing the upper bracket to the hard drive.
-
Remove the upper bracket from the hard drive.
-
Remove the two T8 Torx pins from the other side of the hard drive.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Hooray no temp sensor
Headband Harvest -