Zerodate T26 Scroll Wheel Replacement

Written By: Janice Rullan
  • Comments: 0
Zerodate T26 Scroll Wheel Replacement

Difficulty

Easy

Steps

5

Time Required

5 minutes

Introduction

If your Zerodate T26 mouse has a broken scroll wheel or a scroll wheel that is too dirty to clean without disassembly, then this step-by-step guide on the replacement of the scroll wheel is for you! All you need is a simple plastic opening tool to pry the top and a Phillips #00 screwdriver to remove the plates. Replacement scroll wheels can be ordered online.

  1. UZSAHiJ2xxBGmZ2X
    UZSAHiJ2xxBGmZ2X
    dgllQwSpD1RQXPI5

    • Remove the top shell of the mouse by using the iFixit opening tool to carefully pry the top shell apart from the bottom plate.

  2. wTaxkf6N3YrQ6lpO
    wTaxkf6N3YrQ6lpO
    xgTEPa2FsbIlxefc

    • Remove the adhesive pads using precision tweezers or the iFixit opening tool.

    • Adhesive pads are located on the bottom of the mouse.

  3. Xy1bcHdsBCBqsfGN
    Xy1bcHdsBCBqsfGN
    FlBnyj4EloAWcNlO

    • Use a Phillips #00 screwdriver to remove all four 10 mm screws.

  4. LXVB6hFhOT5Gl6mw
    LXVB6hFhOT5Gl6mw
    RyfJktJpAHE3MThR

    • Carefully pull the middle shell apart from the bottom plate.

    • The circuit board should then be visible and attached to the bottom plate.

  5. UBQQtG1OWBPppRpo
    UBQQtG1OWBPppRpo
    JuGX2TwWKvxxnkp2

    • Remove the scroll wheel by pushing it to the right and pulling up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Janice Rullan

Member since: 13/03/23

662 Reputation

0 comments