Zerodate T26 RGB LED Replacement

Written By: Janice Rullan
  • Comments: 0
Zerodate T26 RGB LED Replacement

Difficulty

Difficult

Steps

7

Time Required

20 minutes

Introduction

Are the lights of your Zerodate T26 mouse not functioning when the mouse is on and otherwise working? If so, here’s the guide on replacing your mouse's RGB lights. All you need is a plastic opening tool to gently pry the top, a Phillips #00 screwdriver to open the mouse, and a soldering iron to begin replacing. New LEDs can be purchased online.

  1. UZSAHiJ2xxBGmZ2X
    UZSAHiJ2xxBGmZ2X
    dgllQwSpD1RQXPI5

    • Remove the top shell of the mouse by using the iFixit opening tool to carefully pry the top shell apart from the bottom plate.

  2. wTaxkf6N3YrQ6lpO
    wTaxkf6N3YrQ6lpO
    xgTEPa2FsbIlxefc

    • Remove the adhesive pads using precision tweezers or the iFixit opening tool.

    • Adhesive pads are located on the bottom of the mouse.

  3. Xy1bcHdsBCBqsfGN
    Xy1bcHdsBCBqsfGN
    FlBnyj4EloAWcNlO

    • Use a Phillips #00 screwdriver to remove all four 10 mm screws.

  4. LXVB6hFhOT5Gl6mw
    LXVB6hFhOT5Gl6mw
    RyfJktJpAHE3MThR

    • Carefully pull the middle shell apart from the bottom plate.

    • The circuit board should then be visible and attached to the bottom plate.

  5. UBQQtG1OWBPppRpo
    UBQQtG1OWBPppRpo
    JuGX2TwWKvxxnkp2

    • Remove the scroll wheel by pushing it to the right and pulling up.

  6. HtgXSCY2lHc3fjtK
    HtgXSCY2lHc3fjtK
    6RoNYVTdLtwwrn3V
    3WTES1TYHqaQXsHw

    • Disconnect the battery from the circuit board.

    • Use the precision tweezers to remove the tape from the circuit board.

    • Carefully pull apart the circuit board from the bottom shell.

  7. EJHQtoI5cdOUwvIr

    • Desolder the LEDs from the circuit board and solder on the new LEDs following the soldering guide.

    • Please be sure to review safety guidelines and guided steps on soldering/desoldering before attempting remove of LEDs

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Janice Rullan

Member since: 13/03/23

662 Reputation

0 comments