Xbox Intec 7.2" Color Game Screen Disassembly

Written By: Navy Vet 2015
  • Comments: 0
Xbox Intec 7.2" Color Game Screen Disassembly

Difficulty

Moderate

Steps

9

Time Required

No estimate

Introduction

This guide will assist you disassemble your Intec 7.2" Color Game Screen attachment. Instructions may be similar to the Intec 5.4" Color Game Screen attachment although this is currently unknown.

  1. xeQaZhFGERbSxVML
    xeQaZhFGERbSxVML
    4GOmeKNRlQNiPjIg

    • Top shell is held in place with 4 screws and 6 retaining tabs

    • Remove 2 rubber pads to uncover 2 hidden screws

    • Remove 4 #1 screws

  2. GaSXPlpBL6pCvQZd
    GaSXPlpBL6pCvQZd
    LAT1CRXEjJE5cXHo

    • Take a spudger and disengage the 6 retaining tabs

    • This will be the most time-consuming step. Be patient and take your time.

    • You will hear an audible pop when disengaging the tabs.

    • Remove top housing

  3. ZLg3uSrm6FKtPsNp
    ZLg3uSrm6FKtPsNp
    2JfjIPdfOeGS2SHo

    • Remove 2 #1 screws

    • Disconnect 4 wire harnesses

  4. uTCG1OgBOBOLSCmH
    uTCG1OgBOBOLSCmH
    RS6LiMuIKekZPNbJ
    gPIbVVrKXrxbPLMG

    • Disconnect speaker header

    • It's not necessary to remove the speakers from the housing unless you need to.

    • Disconnect header if speakers need to be removed. Otherwise, this will be done in the next step.

    • Remove 8 #1 screws

  5. PmPxWnYcAG5EIqpL
    PmPxWnYcAG5EIqpL
    oqvdi2GAKnRGXdJr

    • Disconnect 2 headers

    • Lift wires over retaining posts

  6. o6uQiBIxtZmladic
    o6uQiBIxtZmladic
    yjUCwiNlZFDrbaHb

    • Grab the edges of the board and lift up

    • Don't attempt to fully remove the board from the unit yet

    • Disconnect last header

  7. FFNvZfdaJSFe1TUb

    • It's not necessary to remove the screen from the housing unless you need to.

    • Remove 4 #1 screws to remove screen

  8. tQOVorFOhTg1yiZ3
    tQOVorFOhTg1yiZ3
    3WojTTf3CsPtqVYH

    • Remove 4 #1 screws

    • Lift up on tab

    • Remove 3 #1 screws

    • Grab the edges and lift the board up

    • Don't attempt to fully remove the board from the unit yet

  9. fyKVwkQLbhnBLMSR

    • Feed wires through the hinge enough to remove board from unit

    • These 4 headers are soldered directly to the board

    • If this board needs to be entirely removed, feed the wires all the way through the hinge.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Navy Vet 2015

Member since: 26/06/15

7296 Reputation

0 comments