Wii Balance Board Back Cover Replacement

Written By: Cory Olson
  • Comments: 2
Wii Balance Board Back Cover Replacement

Difficulty

Easy

Steps

6

Time Required

10 minutes

Introduction

This guide will demonstrate how to replace the back cover of the Balance Board.

  1. hQqRBnmXANMIaaWW

    • Flip device upside-down so the plastic white board is facing the ground.

    • Locate the four feet in the corners of the Balance Board.

    • Unscrew the three 12.7 mm Phillips screws from each foot cover.

  2. GfnHhyWUckXW333L

    • Remove the gray plastic ring from the actual foot by lifting it up.

  3. JZ6SJOlBkxsg4wmF

    • Separate the loose foot from the device by lifting it up.

  4. S4ExApXeM2MiTA2Y

    • Repeat steps two and three on the remaining four feet.

    how to completely remove and then put back in would be helpful as that's what the title of this post is…. right?

    Nelda Murray -

  5. iMLP1ruj3NcXAceT

    • Unscrew the ten 12.7 mm Phillips #1 screws.

  6. QN5I22yY63PokZv1

    • Lift off the gray back cover.

    Top Anleitung, aber kann nirgends die Platine finden.... Könnt ihr da helfen? Danke!!!

    Dominik -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Cory Olson

Member since: 29/09/14

891 Reputation

0 comments