Vacuum Bissell 2610E Brush Roll Replacement.

Written By: Faizan Shaikh
  • Comments: 0
Vacuum Bissell 2610E Brush Roll Replacement.

Difficulty

Easy

Steps

7

Time Required

20 minutes

Introduction

If the brush roll on your Bissell Vacuum 2610E is worn out and isn't cleaning as well as it used to, it might be time to replace the brush. This quick guide will show how you how to replace the brush roll with nothing more than a Phillips #0 screwdriver and about 20 minutes of your time.

  1. YqPpBAydVYrfHrWU

    • Lay the vacuum flat on the ground, then use a sturdy object to prop up the bottom.

  2. sfurhjYsJ2cRlpYt

    • Use a Phillips #0 screwdriver to remove the eight screws securing the brush housing.

  3. JORNBmbnNSv22Cef
    JORNBmbnNSv22Cef
    dEfCjMgqLrJr5act
    JSWrbibuGuXh3rTJ

    • Gently pull at each corner of the brush housing until it releases from the chassis.

    • Remove the brush housing.

  4. bSebibxHRoAGhUwB
    bSebibxHRoAGhUwB
    RJQl6pExUa2qKrHC

    • Unlatch the two white plastic hooks securing the brush.

  5. bkngqGqmu4KiMcwd
    bkngqGqmu4KiMcwd
    KaXSqeOsyXEuE6QG
    Fa4uNYVSQpjVBbIq

    • Lift the brush up and out of its housing.

    • Keep and reuse the black rubber belt if it's not damaged.

  6. nDYeNWNY3eCQVhUi
    nDYeNWNY3eCQVhUi
    F1LMfHFUtBSYqJGs
    DyfrH1WbBNHcsMJX

    • Loop the black rubber belt around the notched wheel on the right side of the brush, then place the brush roll back in its housing and lock the white plastic latch.

    • Lock the white plastic latch on the left side of the brush.

  7. G1mi3R2SKJeVUAYE

    • Before replacing the top of the brush housing, make sure the black rubber belt is secured around the black notched wheel on the right side of the brush, as well as the notched wheel on the motor.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Faizan Shaikh

Member since: 17/01/22

169 Reputation

0 comments