VTech CS6719-2 Speaker Replacement

Written By: Benjamin Field
  • Comments: 2
VTech CS6719-2 Speaker Replacement

Difficulty

Difficult

Steps

11

Time Required

15 minutes

Introduction

During this guide, the back of the phone will need to be taken off to access the speaker and wires. You will need to use the tweezers to remove the metal “U” shaped clip holding the speaker to the back cover.

  1. p6Wmu36OGRrgBEB1
    p6Wmu36OGRrgBEB1
    1ZgGJSWtCTWfZkF3

    • Push down on the battery cover in the direction of the arrow located on the back of the phone.

  2. DBV2lKknUQaZTjOC

    • Pull the battery cover off of the back of the phone.

  3. GAAsHvSaIZsyQHIR

    • Unplug the battery input cable.

  4. IRCps2BEPXiYhbBP

    • Lift the battery out of the back of the phone.

  5. LKKoSFNYjxMyZMoN
    LKKoSFNYjxMyZMoN
    lONCbpA3PS3X2Nvy

    • Remove the two 9mm screws on the back side with a Phillips #0 screwdriver.

  6. wdb41INRVof5UR6e

    • Use the plastic opening tool and spudger to pry the back side of the phone off.

  7. kvXwUW2SP1PPR2cC
    kvXwUW2SP1PPR2cC
    dVRhrUxRgXGEXOSm

    • Remove the two 9mm screws located inside the back cover at the top.

  8. Uw3kKXwcxTnYm5ea

    • Locate the metal shaped U clip holding the speaker on. Pull up and towards the top of the phone with the flat head tweezers.

    • The clip is loose, it could fall out.

  9. qCYuTPq4V1HboOWA

    • Lift speaker out.

  10. 51ODf5DJ1LSKdTZK

    • Heat up solder joint on the circuit board where the speaker wires are connected.

  11. ylADBURlQqdfaC3M
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Benjamin Field

Member since: 08/02/16

270 Reputation

2 comments