VTech CS6719-2 Charging Wire Repair

Written By: Josh Showalter
  • Comments: 0
VTech CS6719-2 Charging Wire Repair

Difficulty

Difficult

Steps

6

Time Required

15 minutes

Introduction

During this guide, the base will need to be disassembled and then desolder the charging wire connections.

  1. FpowwHuWBO1jDXeG
    FpowwHuWBO1jDXeG
    ytQTv1RfRfgX1BIK

    • Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.

  2. c1jZneNANmHWAWq6

    • Use the spudger to separate the bottom from the top.

    • There are two clips, located top and bottom, that you have to compress with the spudger.

  3. 1yAEFoKqeygrX1ZG

    • Heat up solder joint on the circuit board where the charging wires are connected. Note: This is the CRD- and CRD+ terminals.

  4. VelvNdSUkie2Ny6J

    • Refer to How to Solder and Desolder connections How To Solder and Desolder Connections

    • Note: Ensure the old solder joint is removed.

    • Caution: Soldering iron and joint will become very hot.

  5. pQOOHKSekLofMbYL

    • Heat up solder joint on the base unit where the charging wires are connected.

  6. Qt3MUXLF2opGV1ox

    • Take a wire of solder and apply to joint on board to remove the extra solder.

    • Note: Ensure the old solder joint is removed.

    • Caution: Soldering iron and joint will become very hot.

    • Remove charging wire connection.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Josh Showalter

Member since: 08/02/16

442 Reputation

0 comments