Unnecto Drone M Disassembly

Written By: Esteban Almeida
  • Comments: 0
Unnecto Drone M Disassembly

Difficulty

Moderate

Steps

8

Time Required

10 - 20 minutes

Introduction

This guide will show you how to carefully disassemble the Unnecto Drone M with easily available tools.

  1. KdMkTTlaLiyDHSIC
    KdMkTTlaLiyDHSIC
    6Rc4mNfBYUeIyjeT

    • Place the phone facedown on a cleared work area

    • Remove the back case by applying moderate force to the indentation in the lower left corner of the case.

  2. rScPlTXPxhUnYwxl

    • Grip the top right corner of the battery.

    • Remove the battery by pulling it outwards.

  3. VAPyQBZRypHmkLRy

    • Remove the four screws on the back of the phone using a Philips 000 screwdriver

  4. DcIMkDaudnktoOFO

    • Separate the frame evenly using a plastic opening tool.

    • Be careful, as the frame is thin and can break easily.

  5. dfUmZIJLeLu5ZbUW
    dfUmZIJLeLu5ZbUW
    RybrgEkFfbjiCMv3

    • Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.

  6. tPCeXu3lLxEblWlk

    • Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.

  7. ZtOyTeXjTRLqDP2v

    • Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.

    • The white circuit is flimsy and securely glued to the frame.

  8. q6kPmCPsIFyUagU4
    q6kPmCPsIFyUagU4
    YJVIvfNkCmnB42Sl

    • Set aside the circuit board from the screen protector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Esteban Almeida

Member since: 08/02/18

329 Reputation

0 comments