Uniden D1688 multistation and handset disassembly

Written By: Nicholas Weeks
  • Comments: 0
Uniden D1688 multistation and handset disassembly

Difficulty

Moderate

Steps

14

Time Required

15 - 30 minutes

Introduction

We will teach you how to successfully take apart the phone system to do any repairs and be able to fully but it back together.

  1. jraM3iNcWZtScQGc

    • Unplug the phone from the base by detaching the RJ-11 plug.

    • Flip the base upside down, and use the Phillips #01 screwdriver to unscrew the seven screws (Head size: 5.11mm, length: 8.6mm) on the underside of the base.

  2. IQ3TXYJTb3ZGgKfm

    • Using the spudger, separate the top shell of the base from the bottom shell from the base.

    • Use care when separating the base so the ribbon cable between the top shell circuit board and the bottom shell circuit board is not damaged!

  3. MeaopgKtSIQpCepy

    • Unscrew the 3 screws (Head Size: 4mm Length: 8.6 mm) from the top shell circuit board.

  4. EjZTCeHDbPTUyTSH

    • Unscrew the 2 screws (Head Size: 4mm Length: 8.66) on the small circuit board in the top shell.

  5. JTqoN4COayqxvKh3

    • Disconnect the ribbon cable from the bottom shell circuit board.

  6. VJbbvT1QQSZZOkIF

    • Release the speaker from the locking pin by pushing down on each ending side of the pin and pushing it away from the speaker.

  7. nLFCACygmXEu4fYe

    • Remove rubber keyboard underlay from top shell.

  8. 1bBTEaCaXTeAuPlJ

    • Push the plastic keyboard pieces out of the top shell.

  9. 5pI5Aa6HICFZIVMV

    • Unscrew bottom shell circuit board screws (Head size: 4mm Length: 8.6mm).

  10. CUUSRBSRm1MRELCG

    • The disassembly of the phone base is complete!

    • Now this guide will move on to taking apart one of the handsets.

  11. GkL2HPCEitKmYVLp

    • Slide the battery cover off of the handset, and unplug the battery.

  12. 4AtVGhr1UKhq6BiN

    • Remove the battery, and unscrew the two screws (Head Size: 4mm Length: 8.6 mm).

  13. 5W2pSQyoDQHQU2IP

    • Use spudger to separate the phone shell.

  14. lEcgSMECPIIB2XhV

    • Unscrew the two screws (Head Size: 4mm Length: 8.6mm) on the bottom shell keeping the speaker locking pin in place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nicholas Weeks

Member since: 27/01/15

101 Reputation

0 comments