Uniden D1688 Bottom Circuit Board Replacement

Written By: justin
  • Comments: 0
Uniden D1688 Bottom Circuit Board Replacement

Difficulty

Moderate

Steps

9

Time Required

No estimate

Introduction

We are going to teach you how to remove bottom shell circuit board. By removing this, you will learn how to dissemble the speaker.

  1. kh56cPwhwSTPVMDh

    • Unplug the phone from the base by detaching the RJ-11 plug.

    • Flip the base upside down, and use the Phillips #01 screwdriver to unscrew the seven screws (Head size: 5.11mm, length: 8.6mm) on the underside of the base.

  2. GOAI5MBBFsWOHYxC
    GOAI5MBBFsWOHYxC
    xBWvtsep5QSDomAV

    • Using the spudger, separate the top shell of the base from the bottom shell from the base.

    • Use care when separating the base so the ribbon cable between the top shell circuit board and the bottom shell circuit board is not damaged!

    • Lift the top shell off the bottom, and you have successfully opened the phone base.

  3. LCxUi3FPqgJXwrAX

    • Unscrew the 3 screws(Head Size: 4mm Length: 8.6 mm) from the top shell circuit board.

  4. X4sgRjyihK6AqmOK

    • Unscrew the 2 screws (Head Size: 4mm Length: 8.66) on the small circuit board in the top shell.

  5. vGoUayU4NRsGh2Hp

    • Disconnect the ribbon cable from the bottom shell circuit board.

  6. SpqIpeKZSutyu4XZ

    • Release the speaker from the locking pin by pushing down on each ending side of the pin and pushing it away from the speaker.

  7. rJZ1wArNmCUjMG6J

    • Remove top shell circuit board by lifting the circuit board out of the case

  8. YeYgHTBuATkcqM2X

    • Unscrew bottom shell circuit board screws(Head size: 4mm Length: 8.6mm).

  9. Be3GgcZvRgYFRKNa

    • Lift bottom circuit board from the bottom shell.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

justin

Member since: 26/01/15

419 Reputation

0 comments