Top Shell

Written By: David
  • Comments: 5
Top Shell

Difficulty

Easy

Steps

6

Time Required

5 minutes

Introduction

  1. G6NM132W6R5p2VbN

    • Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse.

    my mouse sucks i peeled off the tape and there is a layer of something blocking the the screw it is a gaming mouse and i got it 2 weeks ago

    Nathan Swercewski -

    My mouse does not have any screws on it what do I do

    Blakemoller -

    Use a spudger

    Toon Konings -

  2. blsrw6EEaUNsNdya

    • Use the Phillips #1 screwdriver to remove four 5 mm screws from the bottom of the mouse.

    • Use the Phillips #1 screwdriver to remove the two 9 mm screws from the bottom of the mouse.

  3. UO3chpQS5RXG1t4F
    UO3chpQS5RXG1t4F
    TfNtlbZGlBS5uJ6u
    nWjXnAHSyKJCY1ac

    • Grab the top shell of the mouse and lift up to remove.

  4. CqLefxVSePTeFDI6

    • The capacitors on this board can release stored electrical energy if touched.

    • Touch your capacitor discharge tool to the capacitor leads on the board to release the stored energy. If leads are inaccessible, wait until you've removed the board from the mouse body.

    the caps don’t hold a high enough voltage to hurt you though.

    Ted Moss -

  5. 6gTqEGUlpB5RQDtf
    6gTqEGUlpB5RQDtf
    ASPfqpliF2BsEpj4

    • Use a spudger to pry underneath the white plug and pop it out to disconnect the upper board from the lower board.

    Step 5… and then?

    Tom Aud -

  6. TQRN2hvbvwvUomGJ

    • Remove the 5 mm round head screw holding the middle piece to the top piece.

    • The outermost shell will now separate from the middle structure.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

David

Member since: 16/01/13

1156 Reputation

0 comments