Teenage Engineering OP-Z Back Cover Replacement

Written By: Tobias Isakeit
  • Comments: 0
Teenage Engineering OP-Z Back Cover Replacement

Difficulty

Very easy

Steps

3

Time Required

30 seconds

Introduction

Use this guide to open the OP-Z and replace the back cover.

  1. 3P3PtudTARX4VYYo
    3P3PtudTARX4VYYo
    wV3ZGSxOE1EQcKRX
    kabawgJinAQaRfXx

    • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

    • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

  2. pueLJe1vTPDuZsOa
    pueLJe1vTPDuZsOa
    QbptcMmcnDwpxrCE

    • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

    • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

  3. QCjZngZMmxyi3pxU

    • Remove the bottom plate including the rubber feet.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tobias Isakeit

Member since: 31/03/14

116775 Reputation

0 comments