Sunbeam Snow Cone Maker Dasher Replacement

Written By: Thomas Falcon
  • Comments: 0
Sunbeam Snow Cone Maker Dasher Replacement

Difficulty

Moderate

Steps

3

Time Required

5 - 15 minutes

Introduction

  1. fUYrTeT6ioZCag1U

    • Push the button on the back to release the lid. (Missing on this example device.)

    • In the photo on the device page it is red.

  2. ZuENm4aPVSnPKStU
    ZuENm4aPVSnPKStU
    pYGcoDaCKvMDT4TF

    • Unscrew the dasher by holding it in the middle and turning clockwise.

    • You will have to spin it quite a bit.

    • Remove the dasher.

    • Alternately, you can continue to step 3 to further disassemble the dasher components.

  3. VZ3ZJgS2CJDJSUMj
    VZ3ZJgS2CJDJSUMj
    A22JwLSshbkssUNk

    • To take the dasher apart, remove the three 5.5 mm Phillips #00 screws embedded in the plastic. **The 3rd screw is behind the hand in the picture

    • Carefully pull the two pieces apart.

    • When you've finished taking apart the dasher, you should have two parts that are shown in the second picture in this step.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Thomas Falcon

Member since: 24/03/15

107 Reputation

0 comments