Introduction

Once you have removed the cover the capacitor (a black cylinder that has 330v capacity) will be attached to the circuit board by a thin ribbon. Be careful with the ribbon.

  1. Y1IX5SBMJPiEmZ2C
    Y1IX5SBMJPiEmZ2C
    lKmERRIMmRdGvIOR
    MklhqKaFmTbTyZQn
    • Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

  2. wp5MAQvUCHJioBqg
    wp5MAQvUCHJioBqg
    V6goUYYF2LoFwGJX
    IRF1m2W4wQdoUx2x
    • Take off the front part of the case with a plastic opening tool.

  3. owKMdugyXeJT2hU1
    owKMdugyXeJT2hU1
    iMcTM3uAHjktqKmH
    • Pull off the two silver side pieces on the left and right sides.

  4. TEtWsbibCQM1AFGV
    TEtWsbibCQM1AFGV
    f3qUeyXsAaBb4aCf
    • Remove the main back piece. It should easily lift off.

  5. xsbeeqFcAyhfHlZA
    xsbeeqFcAyhfHlZA
    KFThxPsWWSgDsXtC
    owTw6cV4WmGaVRWR
    • Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

  6. o5t3g64xNwW1PvUq
    o5t3g64xNwW1PvUq
    hEJsEpWG3oXWKFTi
    ZDIALSaYLLnKORK5
    • Lift the capacitor out and gently pull it away from the control board to unplug the ribbon attached to the side of the circuit board. Be careful not to bend the ribbon.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Douglas Howe

Member since: 08/01/15

510 Reputation

0 comments