Sony Cyber-shot DSC-P52 Outer Case Replacement

Written By: Trevor
  • Comments: 0
Sony Cyber-shot DSC-P52 Outer Case Replacement

Difficulty

Moderate

Steps

7

Time Required

2 - 10 minutes

Introduction

This guide is used for taking apart the case to fix many of the issues of the Sony Cybershot DSC-P52.

  1. Zdifga6btoHisELE

    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. dti2SEuQUx1wHLPb

    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. RIWPa3odMwLExFdN

    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. NJMrDPPJbpBLcnNF

    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. oAAMsW2xjYxNjqmm

    • Open the case as shown.

  6. ukQVEFTlNGv4PJ2G

    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  7. HAvdOMHnKpQhaqsZ

    • Pull the ribbon cable out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Trevor

Member since: 20/01/11

295 Reputation

0 comments