Sony Cyber-shot DSC-H200 LCD Screen Replacement

Written By: Elizabeth Morrison

Comments: 1

Sony Cyber-shot DSC-H200 LCD Screen Replacement

Difficulty

Moderate

Steps

Time Required

15 minutes

Introduction

In order to change a broken screen, you need to get into the body of the camera. We will show you how to not only take apart your camera but also how to replace a broken screen. Properly following the steps included will ensure a safe and easy LCD Screen replacement.

Tools

Step 1

Using a screwdriver, remove the five 6mm screws located on the back panel.
Using a screwdriver, remove the two 3mm screws located on the back panel.

Step 2

Using a screwdriver, remove one 6mm screw on the front panel.
Using a screwdriver, remove two 3mm screws on the front panel.

Step 3

Open the SD Door, unscrew and remove the single 6mm screw closest to "PUSH IN/OUT" under the SD card slot.

Step 4

Remove the back panel (the LCD and motherboard are exposed).

Step 5

Using a screwdriver, remove the three 4mm screws that attach the LCD to the camera motherboard. (The LCD is contained in a holding plate, attached to the motherboard with a ribbon cable.)