Introduction

The E-mount, the interface between a camera body and a lens, can be easily replaced when it's time to change a dented or non-functioning E-mount. E-mount is also referred to as a lens mount when the camera it is attached to has an interchangeable lens.

  1. Djff1HT2WBBRw4sT
    Djff1HT2WBBRw4sT
    GONt6qQUPuY4nYLN
    • While completing this guide, do not touch the image sensor (the center rectangle encircled by the lens mount).

    • Unscrew the 4 silver 1.2 mm Phillips #000 screws along the front outer lens mount.

    • Applying extra force to unscrew these 4 screws may be necessary.

    • Detach the outer lens mount ring.

  2. HBQhYTd3o631BXgC
    HBQhYTd3o631BXgC
    a2Up1k6wBDPb2vt4
    • Pay attention to the positioning and order of the spacing rings for reassembly.

    • Using your fingers, pull out the first black spacer ring.

    • Repeat the previous step for the second silver spacer ring.

  3. xaQqFJTwkcKBAmaJ
    xaQqFJTwkcKBAmaJ
    2pvEAmqVq2y6MPgg
    tycMbfI1KSoBYpMq
    • Unscrew the 2 silver 1.2 mm Phillips #000 screws on opposing sides in the lens ring area.

    • Using your fingers, easily pull off lens housing. This will complete the removal of the E-mount.

    • The lens release button and the small spring underneath will be loose.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrea Tobar

Member since: 28/09/15

294 Reputation

0 comments