Skullcandy Crusher Wireless Folding Hinge Replacement

Written By: Val
  • Comments: 6
Skullcandy Crusher Wireless Folding Hinge Replacement

Difficulty

Moderate

Steps

5

Time Required

10 - 20 minutes

Introduction

You will use this guide to replace the folding hinge in a Skullcandy Crusher Wireless headphones. Replacement folding hinges can be bought online or taken from another Skullcandy Crusher Wireless headphone.

  1. 1iKZxiFHjbLtCeZg
    1iKZxiFHjbLtCeZg
    MJXMY4xZMZMOBjER
    aQJ623EBCwPsxUXx

    • Extend and fold the hinge of the headphones you are trying to replace.

  2. XNaRdPv1ArsoskYp
    XNaRdPv1ArsoskYp
    BTNKgYCksxbGUhJU
    PVhVDjdeWK4RFHqt

    • Remove two 14 mm Torx T6 screws on the underside of the headband.

    Any idea where to find these specific screws online? Have been searching EVERYWHERE 😬

    Tessa Verstraete -

  3. vHvrsWRgHxsUI4mM
    vHvrsWRgHxsUI4mM
    QSIe3YGDnfJKDdg6
    OlnlyCE6gYOCVE2F

    • Pry the speaker away from the headband with a slight force.

  4. PQhDVpaoNPqpdOGr
    PQhDVpaoNPqpdOGr
    NDxxLBqwZDOvGyJ2
    VAhqvZrYeNVEMqOK

    • Remove two 5 mm Phillips #1 screws on the underside of the headband.

  5. Lid2MQaHQZC4tZTx
    Lid2MQaHQZC4tZTx
    tSSMUYHTWEKmvA5Z

    • Remove the top plastic part of the hinge.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Val

Member since: 01/04/22

1059 Reputation

5 comments

Hello. Any idea where can i buy the folding hinge from? thx!

Liviu -

Hi, Like the explanation but can you tell me where to buy tge folding hinge?

Menno de Gier -

I'm 3D printing these here https://www.ebay.co.uk/itm/364153346438

Stronger than original.

Eatfire -

This is my alternative solution, albeit a temporary one. Sharing for people that end up here through search engines.

----

I figured out a temporary fix. I am posting this for others arriving here from search engines and the like. I assume OP's problem has long been solved. My fix is based on somebody else's fix.

I have 3D printed parts on the way, but my 'design' may actually press down on my ears better than the original. 🤔

What you'll need:

-Tie rip 2 mm
-Tie rip 4 mm
-Drill + 1,5 mm drillbit for metal
-Strong thin elastic.

-Pliers (for making sure the tierips are real tight.)

https://guide-images.cdn.ifixit.com/igi/...

Cus7od35 -