Shark Rocket Zero-M Belt Replacement

Written By: Nadia Martinez
  • Comments: 2
Shark Rocket Zero-M Belt Replacement

Difficulty

Moderate

Steps

6

Time Required

15 - 20 minutes

Introduction

This guide is intended to show how to access, remove, and replace the belt on a Shark Rocket Stick Vacuum with Self-Cleaning Brushroll. This replacement may be necessary if the brush roller is turning slowly or not at all.

  1. KFbJ5GTgYlMFNjUF

    • Flip the vacuum on its right side.

    Where do you buy a new belt for this model? The manufacturer's website doesn't offer any purchases for a replacement belt, last I checked.

    Chastiny Ellingworth -

  2. 1yu5aBtCDbcX5evr
    1yu5aBtCDbcX5evr
    J3ggqRJkjC4Sa5sF
    vFjNrTVi3iPZNRwb

    • Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

  3. ENmAOHsHNJiaCfBY
    ENmAOHsHNJiaCfBY
    ctZeFnI3VQc2anq5
    FJsdMobkJAB5VpBx

    • Turn the vacuum face down.

    • Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

  4. 1NYN6HRlI2Ucmbge
    1NYN6HRlI2Ucmbge
    dbMVf3QqeMrOUpRg
    aCNLHQSkUL2DLOSJ

    • Use a spudger to pry the side of the vacuum open.

  5. vGRAg1a1qGKTwpGH
    vGRAg1a1qGKTwpGH
    WCPf1mLO5flZVT5c
    V6gNHunLVQOAqIMX

    • Use a spudger to pry the old belt away from the two gears.

    • The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.

  6. SNMcntTlWhBANykN

    • Repeat on the other side of the vacuum.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nadia Martinez

Member since: 15/04/21

133 Reputation

One comment

What is the belt part number looking but can not fine.

Help would be greatly appreciated thank you

jason kennedy -