Introduction

If the indicator lights don't appear to be functioning despite being plugged in, a faulty control panel might be the culprit. Before doing any repair/disassembly on your Shark Professional Steam Pocket Mop, make sure to unplug both the mop and empty the water tank for your safety.

  1. sSj2BObLicqGQUhT
    sSj2BObLicqGQUhT
    OiLp3ECROyqn3fIs
    • Unwrap the power cord from the handle.

    • Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.

    • Pull the handle to separate it from the body.

  2. ppJKUvTuaoSMtgqh
    ppJKUvTuaoSMtgqh
    OH1kWoOJki52fNmi
    HlnivbU3kmndm3HF
    • Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.

    • Remove the plastic cap.

  3. 55qspu6tHRWgJhpP
    55qspu6tHRWgJhpP
    BNddb6swXNqJeQAS
    • Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.

    • The third screw is directly on other side of the bottom screw in the photo.

  4. iouPbctQpvVuTZim
    iouPbctQpvVuTZim
    J1Fcv2DNRIJDxpVq
    ddIdBungoBrlZHoR
    • Remove steam control button cover with a metal spudger.

    • Remove the two 12.0 mm Phillips head #2 screws underneath.

    • Remove the plastic rim with clear plastic cover.

    Don’t remove the whole cover!!! Only remove the label! I now have three broken screws and a steam mop that is junk! Please be more clear!!!

    Martha m -

  5. WHAMNA4BVTLRLJ3q
    WHAMNA4BVTLRLJ3q
    FuD1nOn5Nhrf1O3C
    54VbPwUAqJ3MPJDt
    • Remove the Shark logo decal on the front of body using a metal spudger.

    • Remove the two 12.0 mm Phillips head #2 screws underneath.

    • Pull out the plastic cover to remove.

  6. 1YpMiWImraCXNOp1
    • Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

  7. QZXmrrVF5vu32Pdc
    QZXmrrVF5vu32Pdc
    gWvhDVpZgItIGh4O
    • Remove the two 12.0 mm Phillips head #2 screws. Disconnect the control board.

    • Disconnect the control board

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brett Wilson

Member since: 12/02/18

992 Reputation

0 comments