Screen Prerequisite (No LiDAR Assembly Removal)

Written By: Chayton Ritter
  • Comments: 0
Screen Prerequisite (No LiDAR Assembly Removal)

Difficulty

Difficult

Steps

3

Time Required

1 - 2 hours

Introduction

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

  1. hb4aWKRHCDmmSRVB
    hb4aWKRHCDmmSRVB
    B3Xy2Vxj4eK5lSVE
    cVNQAyeKgZnZyBTC

    • Use the pointed end of a spudger to pry up and disconnect the top two display cables.

  2. ZbHWsCPOofIWHcNt
    ZbHWsCPOofIWHcNt
    tJApCQr5ufqJPfiP
    bsoH3fv41niYEysg

    • Disconnect the two remaining display cables.

  3. dnQviK5MA3rPPWbO

    • Grip the right edge of the screen and lift it away.

    • During reassembly, before installing a display, remove any remaining adhesive from the frame, and clean the glued areas with high-strength (>90%) isopropyl alcohol and a lint-free cloth. This helps prep the iPad for fresh adhesive and ensures that it will bond properly.

    • If you plan to reinstall your existing screen, remove any remaining adhesive from the back and clean the adhered areas with isopropyl alcohol.

    • Follow this guide to install pre-cut adhesive strips on your iPad before sealing it up.

Author

Chayton Ritter

Member since: 21/08/20

17428 Reputation

0 comments