Introduction
If your control/menu buttons aren't working on your camera, this guide will walk you through replacing them.
Tools
-
-
Open the case of the camera using your plastic opening tool.
-
Start on each end, working the tool into the opening and popping the casing up. Then work your way down the longer sides (top and bottom).
-
-
-
Using your Phillips #000 Screwdriver, remove one 3.2 mm screw above the menu buttons panel.
-
Next, remove the two 3.2 mm Phillips #000 screws to the left of the menu buttons panel.
-
-
-
Flip the screen back over.
-
Using the plastic open tool, flip open the black retaining plastic piece holding the larger ribbon in place.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.