Samsung WB2200F Face-plate Replacement

Written By: James Julian
  • Comments: 0
Samsung WB2200F Face-plate Replacement

Difficulty

Moderate

Steps

7

Time Required

8 minutes

Introduction

This guide will show how to remove the face-plate of the Samsung WB2200F, and can be used to replace a broken face-plate or replace internal components of the camera

  1. XoCGLqOBEAIyVHsP

    • Place the camera upside down on a hard surface such as a table. Make sure that the battery compartment is visible.

  2. BGbuQMwAI2jCuNLW

    • Twist the nob counter-clockwise while pushing cover to the left. Then pull the cover up to reveal the battery.

  3. tJAwAriIyfWMHBYV

    • Slide the blue tab to the right to release the battery.

  4. Aov1CYMjd1VTmuNp

    • Carefully slide the battery out of the camera. It can then be replaced with a new battery.

  5. DBOPBfEdTVetrMhT
    DBOPBfEdTVetrMhT
    QaqoeHtBmw4xg5cC
    kRZRwjYNZfMxaxBB

    • Remove the 6mm screws located on the bottom and sides of the camera using the using the screw driver with the JIS size 000 head.

  6. Pdkm2uHVQfnsvJFk

    • Remove the two 6mm screws located underneath the battery cover using the same screw driver with the JIS size 000 head.

  7. qhwCM2qQdwRDLZxe

    • Carefully pry the face-plate away from the body of the camera, starting from the battery compartment. It should come off without too much trouble, although it may require force.

    • Make sure to not damage any of the electronic components of the camera

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

James Julian

Member since: 07/03/16

201 Reputation

0 comments