Samsung WB2100 Flash Assembly Replacement

Written By: McGregor Coyne
  • Comments: 1
Samsung WB2100 Flash Assembly Replacement

Difficulty

Moderate

Steps

6

Time Required

1 - 2 hours

Introduction

Is your flash not working anymore? This guide will show you how to replace the entire flash assembly and light up your pictures.

  1. fS5UcOW6LpCqCOJb
    fS5UcOW6LpCqCOJb
    eOPywfoJRcOkfpYX
    QocaMwx5jY3oTEEj

    • Remove the 7 screws on the outside of the camera

    • Two 5 mm PH000 screws on the right side of the camera body

    • Four 3mm PH000 screws on the bottom and the left side of the camera body.

    • Use the plastic spundger to push the back casing out. Start from the right side and work your way clockwise around the case.

    • The HDMI / AV tab might fall out. this is supposed to happen as it is not screwed into place in the back casing.

  2. AfPAZLMC41x14QqQ
    AfPAZLMC41x14QqQ
    3DgBC4iBlAHnrYUa

    • Disconnect the set of wires from the back casing to the motherboard. Do this by using the plastic spundger to flip the black tab up and the wires will pull out.

    • Unscrew the four 3 mm and two silver 1 mm PH000 screw from the green logic board

  3. 2jSuK2DUGTojtChP

    • Unscrew the two 3 mm screws from the top cover with the PH000 driver.

    • Along with the one 2 mm screw, also a PH000 screw.

  4. hSw6FdgwU6lSSYF6
    hSw6FdgwU6lSSYF6
    XUbDJFca6JoAEcPO
    CtWXYAZrLwoUjjTg

    • Use the spudger and pry the top cover off starting on the left side and working your way down.

  5. OTwvhQbIrYOvDNWx

    • After the top is disconnected, fold it back so the two PH000 flash screws are accessible and remove the cover.

  6. csghpCESQAbtLfZ5
    csghpCESQAbtLfZ5
    V3mj2PJcOnH3hQCk
    YLkBoKPObKC1Jhg2

    • Remove the flash bulb from the red housing and clear cover. Do this by pushing back the flash bulb back out of the red housing.

    • When reassembling make sure the tab on the flash cover faces up.

    • Desolder the wires from the circuit board. Learn more about soldering here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

McGregor Coyne

Member since: 20/01/16

248 Reputation

One comment

Hola, mi camara wb2100 se queda colgada y los comandos responden pasados varios segundos y al iniciar arranca con valores por defecto, es decir que no graba las configuraciones luego que se apaga, es muy molesto usarla de esta forma y quisiera saber si hay forma de resetearla para ver si se soluciona el problema. Alguien tiene idea de como resetear esta cámara? se agradece vuestra ayuda.

Alain Chiesa -