Samsung S85 Rubber Door Replacement

Remove 4 screws from bottom of camera

Remove 2 screws from side of camera

Remove 2 screws from side of camera

Squeeze area noted by blue square and pull outside shell apart from remaining camera.

Remove 6 screws identified by red circles

Remove 3 screws identified by orange circles

Gently remove orange circuit ribbon identified by red square

Gently remove narrow orange circuit ribbon identified by blue square

Using a soldering iron, remove solder from wire identified by red circle

Using a soldering iron, remove solder from black and red wire identified by orange circle

Using a soldering iron, remove solder from wire identified by yellow circle

Using soldering iron, melt away solder and warm up metal located at top of circuit board as shown in picture

Repeat step two to three times until board feels flexible to bend

Slowly bend circuit board upwards (towards power button) until at 90 degree angle with remaining part of camera.

Remove black rubber door located on side of camera closest to lens using tweezers.