Introduction

This guide will take you through the steps of removing parts of your device to reach and replace the lens

  1. NOOZO6RYDpGXQjPj
    NOOZO6RYDpGXQjPj
    mLoqktAWipPKsgWG
    BKvmxXpKgDpNmdLj
    • Placing your thumb on the battery cover, push outwards, away from the camera in the direction the arrow is pointing. If done correctly when it's completely unhooked, the latch will open.

  2. oDFEpog42d4tHiKR
    oDFEpog42d4tHiKR
    2slY2GyZNtpeKcWM
    • Tip the camera as to gently slide the batteries out of the camera.

    hello

    This camera which battery is use

    Saidali R -

  3. W3Zr2hdBrJ5vlQhY
    W3Zr2hdBrJ5vlQhY
    DEinWESufBSYXLTN
    MT5roF3lIUgWN352
    • All screws in this camera are removed using the Phillip Screwdriver #000 bit. Also, all dimensions included refer to screw lengths.

    • Locate and remove the six 4mm screws on the sides of the camera.

  4. DFqDAb5GBSyAcTXC
    DFqDAb5GBSyAcTXC
    C1oIAaxSosO12Vlv
    • Use the plastic opening tool to pry open the back case, following alongside the edge of the case if need be.

  5. GKALXMA6SVEE6JKk
    • Once the back case is removed, use the plastic opening tool to gently pry off the front case.

  6. EFBc61pybF6WudtR
    • Move the screen down, out of the way to remove the two 3mm screws beneath it.

  7. XnIAeyeLbYLUFSZL
    XnIAeyeLbYLUFSZL
    LJEh1FjAQYlsP25B
    • Remove the 6mm screw labeled in the picture.

    • Remove the three 3mm screws.

    • Then proceed to flip the screen to the other side to remove the other 6mm screw.

  8. PNtl1d1TcGjIDpEF
    • Proceed to carefully pull the ribbon cable out by using the little circular tabs sticking out on either side.

  9. rgVBHvWJb1XovFqZ
    rgVBHvWJb1XovFqZ
    fMwAZsKAPEKZtaIk
    • Proceed to slowly pry off the mother board with the plastic opening tool by removing it at the micro USB attachment.

    • Then carefully manually pry off the golden colored section near the camera wheel until all of it is off.

  10. ZLg1ZZIHEItO3VBk
    ZLg1ZZIHEItO3VBk
    yETVnf3VMyFTXG5Z
    • Finally, remove the final 3mm screw marked in the picture.

    • Lift the camera lens out of the lens compartment.

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Sepulveda

Member since: 06/03/17

446 Reputation

One comment

Brilliantly explained. Makes it look so easy… even a fool such as I could follow the instructions.

frankasensale -