Introduction
Replace the SD card on your Samsung PL200 to provide more memory space as well as replacing a defective card. This is a simple replacement that requires no tools and can be completed in less than 2 minutes.
-
-
Flip Samsung PL200 over to access battery/SD card compartment on the bottom. There is a sliding release button (labeled 'OPEN') that can be slid sideways to open the battery/SD card compartment.
-
Slide this button in the direction that the arrow is pointing to release and open the spring loaded battery/sd compartment door.
-
Once opened, the SD card should be visible.
-
-
-
Once the battery/SD card compartment is opened, simply push the SD card down to activate the spring loaded ejector.
-
This will cause the SD card to raise up enough to allow you to grab it with your fingers.
-
Use your fingers to remove the old SD card.
-
-
-
Insert the new SD card into the SD card slot.
-
Make sure to push it down all the way until it clicks and remains flush with battery.
-
Close the battery/SD card compartment.
-
To reassemble your device, follow these instructions in reverse order.
