Samsung HMX-W300 USB Port Replacement

Written By: Robert
  • Comments: 0
Samsung HMX-W300 USB Port Replacement

Difficulty

Difficult

Steps

11

Time Required

20 minutes

Introduction

To replace USB port, remove battery first and then remove the USB port while connected to a wire.

  1. BNmHkWcQcrODFUKD
    BNmHkWcQcrODFUKD
    AI5JlIaFPUNjHtVt
    uswsBt2EYeXqvYfo

    • To remove the wristband of the device, grab the middle loop and pull the band through.

  2. K3WKCATvQHQ1M4W5
    K3WKCATvQHQ1M4W5
    JIITAkUOIuwtKUmK

    • Remove four screws with a Hex 1.5 mm screwdriver.

  3. RZj2rOK6nIHckbVo
    RZj2rOK6nIHckbVo
    GnC2SIBLqQC23o5F
    VUtuooT4nFGseUvl

    • Open the HDMI door on the side of the camera.

    • Remove the single screw using a Phillips #00 screwdriver.

  4. NrSjitKJob6b3qMd
    NrSjitKJob6b3qMd
    CDKulyPt123tnQCR
    N4fKfaAwHSpnoEeO

    • Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.

    • Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

  5. gnNBexMYluHVlOnX
    gnNBexMYluHVlOnX
    EnJFUx2WaFRdfwEK
    SyyOmVPrFAlUtFSi

    • Pull the wire ribbon out with a pair of tweezers.

  6. mnAF1CTxyCVVenFs
    mnAF1CTxyCVVenFs
    ZrTonbIPjDgfvBmP

    • Remove the four screws from the battery housing using a Phillips #00 screwdriver.

  7. EGSgGoIKWoD2u5om

    • Use the iFixit opening tool to pry the battery housing open.

  8. NSfqPAABvlWYwNwK
    NSfqPAABvlWYwNwK
    uTw2HU5qGEDCF3uy
    PpeA6AMWxedbFkeQ

    • After removing the battery housing, take the battery out.

  9. bHYIGYkOAC1vwrC6
    bHYIGYkOAC1vwrC6
    JH5ygJPEqb4IGqmx
    UCUdQMB2AhAxKut3

    • Use an iFixit opening tool to pry up the plastic cover.

    • Use tweezers to remove the wire from the slots.

  10. wFnf3eynl4DAq3rQ
    wFnf3eynl4DAq3rQ
    rdTsBLBAUFFelrUa

    • Remove both screws from the USB port using a Phillips #00 screwdriver.

  11. Anr1eWPmMZDvjvAg
    Anr1eWPmMZDvjvAg
    QtcYFlMiMkTunEQI

    • Push the USB port inside the case to remove it from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Robert

Member since: 22/01/15

966 Reputation

0 comments