Samsung HMX-W300 Motherboard Replacement

Written By: Robert
  • Comments: 0
Samsung HMX-W300 Motherboard Replacement

Difficulty

Difficult

Steps

10

Time Required

25 minutes

Introduction

Shows how to replace motherboard with pictures and words. Removal of motherboard requires opening the camera and unscrewing screws from motherboard to remove from rear case.

  1. BNmHkWcQcrODFUKD
    BNmHkWcQcrODFUKD
    AI5JlIaFPUNjHtVt
    uswsBt2EYeXqvYfo

    • To remove the wristband of the device, grab the middle loop and pull the band through.

  2. K3WKCATvQHQ1M4W5
    K3WKCATvQHQ1M4W5
    JIITAkUOIuwtKUmK

    • Remove four screws with a Hex 1.5 mm screwdriver.

  3. RZj2rOK6nIHckbVo
    RZj2rOK6nIHckbVo
    GnC2SIBLqQC23o5F
    VUtuooT4nFGseUvl

    • Open the HDMI door on the side of the camera.

    • Remove the single screw using a Phillips #00 screwdriver.

  4. NrSjitKJob6b3qMd
    NrSjitKJob6b3qMd
    CDKulyPt123tnQCR
    N4fKfaAwHSpnoEeO

    • Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.

    • Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

  5. gnNBexMYluHVlOnX
    gnNBexMYluHVlOnX
    EnJFUx2WaFRdfwEK
    SyyOmVPrFAlUtFSi

    • Pull the wire ribbon out with a pair of tweezers.

  6. bCGHA24IuDjnCEPf
    bCGHA24IuDjnCEPf
    OBPC5WMFQUG6nTCm
    4uK1oXb1WBgiTkXb

    • Use tweezers to remove the tape.

  7. y6knPmYmxRSoug3v
    y6knPmYmxRSoug3v
    MUf5Z52W2YQpDODI

    • Use tweezers to grab the wire ribbon, then pull the wire out of connection.

  8. vN6cVWosRlVFQTbb
    vN6cVWosRlVFQTbb
    IVUSvictmJhMeNer

    • There are 5 Phillips size 00 screws. Remove all 5 screws.

    • Wire ribbon is attached to the motherboard.

  9. t3LFxqtTXAwUgc41

    • Pry the motherboard up using the plastic opening tool.

    • Be careful there is a wire ribbon holding the motherboard.

  10. wStDJOHJobeBiIpH
    wStDJOHJobeBiIpH
    qZjfKA1WpEKpPxvf

    • Use tweezers to disconnect the wire as shown. This will loosen the motherboard from the rear case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Robert

Member since: 22/01/15

966 Reputation

0 comments