Introduction
Use this guide to remove the outer casing of your device.
Tools
-
-
Pull the release tab away from the battery.
-
Slide the battery towards the release tab and then pull the battery away from the camcorder.
-
-
-
Rotate the camcorder so that the strap side is facing you.
-
Locate and remove the three 4.5mm Phillips #00 screws around the hand strap.
-
-
-
Rotate the camcorder so that the battery slot is facing you.
-
Located in the top left corner of the battery slot, remove the 4.5mm Phillips #00 screw.
-
-
-
Rotate the camcorder so you are looking at the bottom of the camcorder.
-
Locate and remove the last three 4.5mm Phillips #00 screws.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
