Introduction

This guide is used only as a precursor to the battery, vibrator motor, and heart rate monitor removal and replacement.

  1. yLLecbt3edFGYJMs
    • Lay the watch face-down on a flat, stable surface.

    Be sure to proofread carefully.

    Dan Brown -

  2. IYSNXgiiPw4x3KHB
    • Press the watchband down against the work surface.

    • Press the tip of a flathead screwdriver against the edge of the spring-loaded holding pin.

  3. NGa4yx2VkVuCmWky
    • With the spring-loaded pin pressed in, the watch band should release easily.

    • Gently pull the band away from the body of the watch.

    • Repeat steps 2 and 3 for the opposite side.

  4. IZfmffMxZBaT36Ir
    • With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners.

  5. txR4BDaGvLNwUTPC
    • Using a Torx-T5 screwdriver, remove each of the four 4mm screws and set them aside.

  6. jRbxYSwbk5cnIRpC
    • Gently work the plastic opening tool under the top edge of the watch’s back cover.

  7. CAItSWh5GjYBsqNW
    CAItSWh5GjYBsqNW
    nYlxXwqfmxDlE2DX
    • With the watch’s back cover pried loose, gently lift it away from the front half of the watch.

    Good action shots here!

    Dan Brown -

  8. fOLomDeDMq3OJBy3
    • Lay both halves of the watch body assembly face down (with internal components facing up).

Conclusion

To reassemble your device, follow these instructions in reverse order.

Keith Cooper

Member since: 25/09/14

1241 Reputation

One comment

Mention the screwdriver in the tools needed section.

Dan Brown -