Introduction

Prereq to remove the motherboard from the interior midframe.

  1. 2UZxViQPO2k2RFZp
    2UZxViQPO2k2RFZp
    wBxDruUCZmtvHjMG
    • Carefully wedge the tip of a spudger underneath the antenna cable connector.

    • Delicately lift the spudger directly upwards to disconnect the antenna connector off its socket on the motherboard.

    • Some models have two antenna cables (blue and grey/white). Remove both of the cables.

    Please let someone know about the screw under the camera and flash/heartbeat monitor, holding the motherboard to the midframe. I do not see a step for this before trying to remove the motherboard.

    Jay Bird -

    Same and all so in the s5 I disassembled there was 2 antenna cables the a blue one and a white one.

    daniel willenbrok -

    I also had 2 cables - a blue and a white one.

    Paul Askin -

    I second that: At least with the G900-V, there are two antenna cables, a blue one and a white one, .WARNING: Although each cable is of a unique length, you MUST remember or note which cable is connected to which socket, otherwise reassembly will be impossible.

    OmniWeb Technical Education -

  2. tpmslHdiDRuAdAxn
    • Remove the single 3.0 mm Phillips #000 screw securing the motherboard to the midframe.

  3. 6YCPBDFRyvROcydJ
    6YCPBDFRyvROcydJ
    PKVexURmptSTWSUc
    • Pull, but do not remove, the camera end of the motherboard up from the midframe to allow access to the connectors on the rear.

    • Do not attempt to fully remove the motherboard as it is still attached to the interior midframe by the Micro-USB port daughterboard connector.

  4. cdnZnWhIZVG1YgVv
    cdnZnWhIZVG1YgVv
    xHoK5WScadEodfJp
    • Use the flat end of a spudger to pry the daughterboard connector straight up off its socket on the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Member since: 19/10/12

465332 Reputation

0 comments