Introduction

Use this guide to install a new front-facing camera assembly in your Samsung Galaxy Note.

  1. kG2UScBcTXmHPYVN
    kG2UScBcTXmHPYVN
    r4XSpAUaXIPiQtya
    • Grasp the cap of the stylus and remove it from its slot in the midframe.

  2. PI2tDAugVYFNGMZt
    PI2tDAugVYFNGMZt
    ULINckCfSInHyeXC
    • Pry with a plastic opening tool, or your fingernail, in the divot to the right of the rear-facing camera, near the volume rocker.

  3. MpHKKCVKwRo1RioU
    MpHKKCVKwRo1RioU
    LjfTJSNt4T2cjv6h
    • Lift and remove the rear case from the phone.

  4. SWy2hhjKDS33U3Y3
    SWy2hhjKDS33U3Y3
    GGlu32H1KPjCmsW6
    • Insert your finger in the notch of the battery compartment.

    • Press the battery toward the rear facing camera while pulling outward.

  5. 5BiCRBrtTPyJ4tk1
    5BiCRBrtTPyJ4tk1
    UFTfVPJSKVrPKL5Y
    EJuYT2OyjoQGAbxv
    • Use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot until you hear a click.

    • After the click, release the card and it will pop out of its slot.

    • For reassembly, push the microSD card into the slot until it clicks in place.

  6. 52J2RI4TEZeQ11sJ
    • Remove the microSD card from its slot in the midframe.

  7. hG4veoOGQKGFuZkq
    hG4veoOGQKGFuZkq
    pDBkVSJTftaWxwFB
    • Use a plastic opening tool, or your fingernail, to push the SIM card out of its compartment.

  8. 3ehlDrRM3RjKad1D
    3ehlDrRM3RjKad1D
    xPbkXNKtiPj6Divg
    • Slide the SIM card out the rest of the way with your thumb and remove it from the device.

  9. hNi5V3SbxPG1DZ1M
    • Remove the nine 3.4 mm Phillips #00 screws securing the midframe to the display assembly.

  10. rFPT6b3gYdjYmtS1
    rFPT6b3gYdjYmtS1
    BGPTnIyIZGYetEFv
    • Insert your plastic opening tool to the left of the power button between the midframe and the front panel assembly and pry.

  11. VYiMNujtYmq4HTwa
    VYiMNujtYmq4HTwa
    Da1wnT3vJkTHsRdX
    PEMbIiI53Gg4VTUN
    • Slide the plastic opening tool down the seam.

  12. JdiLLBSNwDBK2cSw
    JdiLLBSNwDBK2cSw
    qLogubShioBGLvqh
    JTIw65fNcodstZe6
    • Insert your plastic opening tool to the left of the headphone jack between the midframe and the display assembly.

    • Slide the opening tool along the top edge of the phone.

    • Continue to run the plastic opening tool around the perimeter of the phone until the midframe is separated.

  13. PHSBcEoqFQgTMAVK
    PHSBcEoqFQgTMAVK
    4amJJFHaMvBcf13p
    • Remove the midframe from the display assembly.

  14. 2GJLfLcrPJ4pMb1M
    • Use the flat end of a spudger to disconnect the headphone jack/earpiece speaker assembly cable connector.

  15. TqgSCa2m2IARCqXC
    • Remove the two 3 mm Phillips #00 screws securing the upper display assembly bracket.

  16. 5WqYdEXtxtaaILp2
    5WqYdEXtxtaaILp2
    xgIZ5YViB6DRTUHa
    • Use a pair of tweezers, or your fingers, to remove the upper display assembly bracket.

  17. XkHQcEjV2v6x3cmU
    XkHQcEjV2v6x3cmU
    bHQnmWVRaDr2hJ4c
    • Using tweezers, or your fingers, remove the front-facing camera assembly.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Member since: 19/10/12

465329 Reputation

0 comments