Introduction

Prerequisite only! Use this guide to remove the back cover on your Samsung Galaxy M31 for repairs.

  1. CUFMfuOLGUMOJbQb
    CUFMfuOLGUMOJbQb
    RSPK3OjRPBoUWPwe
    TWAXoQmdefBwQPeF
    • Insert a SIM card eject tool, a SIM eject bit or a straightened paper clip into the hole on the SIM tray located at the left side of the phone.

    • Press firmly to eject the tray.

    My phone is restarting alone automatically what can I do please

    Oussama Laghezal -

  2. uWaHXIZWK42QenGE
    uWaHXIZWK42QenGE
    LAnecJCHKiALg4VM
    k4Ud5D1gRnuEvw1g
    • Insert an opening pick between the phone assembly and the back cover at the bottom edge of the phone.

    • Slide the opening pick around the bottom right corner to release the clips holding the back cover in place.

  3. hKYSlCA5YNwFAanO
    hKYSlCA5YNwFAanO
    N4KgcFcCYDallpBj
    • Insert a second opening pick between back cover and the phone assembly at the bottom edge of the phone.

    • Slide the opening pick around the bottom left corner to release the plastic clips holding the back cover in place.

  4. 4qebEjKmvfsg5Tc4
    4qebEjKmvfsg5Tc4
    iSd66nU5HAKMWhuT
    • Slide the opening pick along the left side of the phone to release the plastic clips on the left side of the back cover.

  5. wldaB42utZRLkXc5
    wldaB42utZRLkXc5
    TjbFrl4WUBrnki6r
    • Slide the opening pick along the right side of the phone to release the plastic clips on the right side of the back cover.

  6. wD1yufSTYpBZgYCB
    wD1yufSTYpBZgYCB
    ZSQ2HDipWYiWovx2
    LshKtxD1V1UVBxSE
    • The flex cable of the fingerprint sensor is very short and the sensor is likely to disconnect itself during the following removal procedure. Avoid damaging the cable by removing the back cover too quickly.

    • Carefully lift the phone assembly out of the back cover.

    • During reassembly, this is a good point to power on your phone and test all functions before reinstalling the back cover. Be sure to power your phone back down completely before you continue working.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Removal didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Dominik Schnabelrauch

Member since: 23/11/16

201132 Reputation

0 comments