Introduction

Disassemble a Cyborg Mouse.

  1. foSRLwEILamGehdZ
    foSRLwEILamGehdZ
    tCDbTRRvpEZiBVmh
    JfulBS4lmJvmtVR2
    • Use a Phillips #1 screw driver to open the back cover.

    • Gently push away the bottom part on the opposite side to the cable.

    • As in the "push away" step, there should be about 30° between the bottom and top part. Push on the bottom part up, so the fit is tight around the cable. Slowly move parts together to reduce the angle.

  2. YACUCHjero2pt1GV
    YACUCHjero2pt1GV
    XW3e2vnn6Ev5CJ4K
    • Use a Phillips #1 screwdriver to unscrew the big top mouse part with both buttons.

    • Use whatever you find appropriate (I used a screwdriver) to gently push the clips (yellow) and next push to one of the circles (red) to separate the big top part.

  3. whj4IsHGnBoDUXDC
    whj4IsHGnBoDUXDC
    6sxdIrIqHuRIegjx
    • Use whatever you find appropriate (I used a screwdriver) to gently push the clips (red) and use whatever you find appropriate (I used a thin screwdriver bit) to push the pin (yellow).

    • Now if you very gently push to the bottom part of the cover, it should pop out on itself.

  4. UoJgEOn3YAPbTjKO
    • Use a Phillips #00 bit to unscrew two screws on the motherboard.

    • Carefully lift the whole motherboard out of the mouse.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Vaclav Sobotka

Member since: 24/01/16

1 Reputation

0 comments