Introduction

This guides enumerates the steps of removing and replacing the front casing of the SPV Aqua 5800 Camera in order to protect the mechanisms within.

  1. VhVjXRrRZScpjM1K
    VhVjXRrRZScpjM1K
    aKTLLqHRqd5KXA6v
    OvHhCVFcZNsKdJBo
    • Locate the two 3.5 mm screws on the side of the device.

    • Apply pressure to the PH J000 philips head screwdriver and turn in a counter clockwise motion until the screw becomes loose enough to pull out.

  2. 4QIsvPvKGgFiRiTH
    4QIsvPvKGgFiRiTH
    OcXUBcriXmDcHHdk
    • Once you have properly removed the strap hook, locate the two 3 mm screws located on the opposite side of the strap hook.

    • Refer to the prerequisite guide on removing the strap hook for instructions.

    • Place the PH J000 phillips head screwdriver on the head of screw; apply pressure and turn in a counter clockwise motion until screws come loose.

  3. XT1bEY5klgXSuYMj
    XT1bEY5klgXSuYMj
    DpWqWmsnWgLv2DXX
    • Place the plastic opening tool on the crack between the front and back casings.

    • Apply pressure by pulling down on the plastic opening tool to pry the case apart.

  4. KPMK2SjC4aTwNAsR
    KPMK2SjC4aTwNAsR
    TrMYRDeT2uRM1J2J
    • Wedge your fingers in the opening and slowly pull the front casing away from the bottom casing until it complete separates from the device.

    • Using too much force in this step can damage your device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cheyenne Heinen

Member since: 07/03/16

358 Reputation

0 comments