SEGA Genesis Flashback Controller Buttons Replacement

Written By: Viet Nguyen
  • Comments: 0
SEGA Genesis Flashback Controller Buttons Replacement

Difficulty

Moderate

Steps

4

Time Required

15 - 20 minutes

Introduction

This guide will help you replace the buttons in your Sega Genesis Flashback controller. You’ll need a Phillips #000 screwdriver to complete this guide.

  1. OdgpTeYy3wuACEmR
    OdgpTeYy3wuACEmR
    og5ITjXdL5JubPyS
    Ai6QCgIgWaREOKGy

    • Hold the controller with the bottom plate facing up, and gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.

    • Remove the screws on the back of the controller with the Phillips #000 screwdriver.

    • Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.

  2. bgREDVdMnNnIJYgW
    bgREDVdMnNnIJYgW
    I6esookjtDMoM5xw

    • CAUTION: Pull gently on the rubber membranes to avoid tearing .

    • Use two fingers to remove each rubber membrane that rests on top of the buttons.

  3. cGW3icTQEIsGQM2I

    • Pop the button out from the front side of the controller.

    • Pull the button out from the backside using the other hand.

    • All removable buttons can only be placed in their respective holes due to unique groove patterns on the buttons. Keep in mind where each button belongs to make re-assembly easier.

    • All buttons can be removed except for the D-Pad.

  4. WiS1GCRQhyDwIWsX

    • Repeat Step 5 for the remaining buttons.

    • The button should pop out seamlessly and placed to the side.

    • Repeat the prior steps in order to remove all the buttons. Set them aside in an order you will remember to where they belong.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Viet Nguyen

Member since: 17/04/18

220 Reputation

0 comments