Ryobi CSB135L Power Cord Replacement

Written By: Nathanael Winchell

Comments: 0

Difficulty

Moderate

Steps

Time Required

30 minutes

Introduction

This guide will show you how to properly replace the power cord in the Ryobi CSB135L. If the symptoms in our troubleshooting page for a damaged power cord align with the symptoms your Ryobi CSB135L are experiencing your power cord is most likely damaged.

Tools

Step 1

Place the saw on a flat surface.
Make sure the saw is unplugged and unpowered.

Step 2

Remove the six M4x16mm Phillips screws and the two M4.5x35mm screws using a Phillips #2 screwdriver.
Remove the front facing half of the handle assembly exposing the internals of the saw.

Step 3

After removing the handle assembly locate the trigger switch and wire nut in the saw.
Remove the screw from the black wire of the power cord using a Phillips screwdriver. Then remove the wire.
Loosen the wire nut and remove the neutral wire from the power cord.

Step 4

Remove the power cord from the saw.
To insert the replacement power cord, insert the black wire of the cord into the trigger switch and tighten the screw. Take the neutral/white wire of the new cord and insert it into the wire nut and tighten the nut.
Wire strippers may be needed when installing the new power cord to expose the copper wire.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nathanael Winchell

Member since: 16/03/23

689 Reputation