Ryobi CSB135L Guard Replacement

Written By: Nathanael Winchell
  • Comments: 0
Ryobi CSB135L Guard Replacement

Difficulty

Moderate

Steps

4

Time Required

10 minutes

Introduction

This guide will show you how to properly replace the blade guard in the Ryobi CSB135L. If the symptoms in our troubleshooting page for a malfunctioning guard align with the symptoms your Ryobi CSB135L are experiencing your guard is most likely damaged. This guide will show you how to replace it.

  1. 2MNEoYJeoRZaCa4S
    2MNEoYJeoRZaCa4S
    LbYioQ5FIcsQCPUl

    • Remove the central 6mm hex nut and two black washers using a 6mm allen wrench.

    • Remove the old blade.

    • The blade has already been removed from this device.

  2. XDktyUCmLDSy5G4P

    • Remove the M5 x 20 mm screw using a Phillips screwdriver.

    • Remove the black rubber stopper.

    • This allows for 360 degree rotation of the guard.

  3. NmHAhEcepJ5iAXPo
    NmHAhEcepJ5iAXPo
    ITRNOW34t6HmT1IL

    • Remove the four M4 x 16 mm screws holding the blade guard on using a Phillips screwdriver.

    • Rotate the guard as necessary to gain access to all the screws.

  4. XXFDglES1UtTNvBy

    • Remove the guard setup

    • Adjusting the blade depth to allow more room near the guard housing can help with the removal

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nathanael Winchell

Member since: 16/03/23

689 Reputation

0 comments